Beginner’s guide to set up Linksys extender RE7000

Linksys Extender Setup re7000

With the world changing all over, need has arisen for better digital models for modern housing. Equipped with network connectivity round-the-clock, a new-age home is a sight to behold. However, often with digital networks, the issue of range and wireless signal issues is always there. To address these, you have to have a Linksys extender RE7000. The device will help expand your signal range to Wi-Fi dead zones. It will eliminate any signal issue that comes due to certain position of your Wi-Fi router.

Easy installation

Once you buy your Linksys RE7000 extender from a registered vendor, it is time to get it up and running. It is fairly easy. Here’s a quick step-by-step guide to install the device:

Step 1: Plug in your Linksys extender at the spot in between a Wi-Fi dead zone and your router. Wait for the signal light to flash amber.

Step 2: Connect any of your wireless devices to the extender Wi-Fi signal. If you are doing it on the phone, use the system set identifier (SSID) to connect to the device in the wireless network options.

Step 3: Open your web browser and type 192.168.1.1 in the address bar. This will take you to the web-based setup window of the Linksys extender. The interface is easy to use.

Step 4: After you have put in the wireless channel and password information into the web-based setup, click “start”. Wait for the setup to finish.

Step 5: Adjust your device distance over the dead zone in the in-built interface for capturing optimum signal. The indication of “very good” is the one to go with.

Step 6: Connect your device to the network as shown on the list of wireless networks on your device. Enjoy uninterrupted internet service with high speed Wi-Fi range.

Some tips After you have installed your Linksys RE7000 Wi-Fi extender, make sure you keep a check on the network speed at the dead zones. Just call up your service provider if any issue crops up. Sometimes the extender may just need a reset. There are buttons for that on the device itself. Also, keep the device antennas in an upright position to avoid any kind of glitch.

Leave a Reply

Your email address will not be published. Required fields are marked *